Xerox Xerox 8830 Digital Solution with AccXES Controller serial number CNG Leaflet
XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction
29
Quick Start for Plot Nesting (continued)
Setting Nesting Parameters with the
8825/8830/8850 Printer Control Panel
8825/8830/8850 Printer Control Panel
• Press on the Control Panel to take the printer off-line. Press Enter.
• Press
• Press
the
Next key until SETUP PRINTER is displayed. Press the Enter
key to confirm the choice.
• Press
the
Next key until PLOT NESTING is displayed. Press the Enter
key to confirm the choice.
• Press
the
Next key until MODE ENABLE is displayed. Either accept the
factory default setting of OFF, or press the Enter key to change the
setting.
Use the Next key to select ON or OFF.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
setting.
Use the Next key to select ON or OFF.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
• Press
the
Next key until EXCLUSIVE ENABLE is displayed. Either
accept the factory default setting of OFF, or press the Enter key to
change the setting.
Use the Next key to select ON or OFF.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
change the setting.
Use the Next key to select ON or OFF.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
• Press
the
Next key until TIMEOUT is displayed. Either accept the factory
default setting of 5, or press the Enter key to change the setting.
Input a Plot Nesting Timeout between 5 and 300 seconds using the
numeric keypad.
Input a Plot Nesting Timeout between 5 and 300 seconds using the
numeric keypad.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
the PLOT NESTING menu.
• Press
the
Next key until MARGIN is displayed. Either accept the factory
default setting of zero (0), or press the Enter key to change the setting.
Input the Plot Nesting Margin using a number between 0 and 25
millimeters using the numeric keypad.
millimeters using the numeric keypad.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
the PLOT NESTING menu.
• Press
the
Next key until MAXIMUM LENGTH is displayed. Either accept
the factory default setting of 61 centimeters, or press the Enter key to
change the setting.
Input a Plot Nesting maximum length between 21 and 2438 centimeters
using the numeric keypad.
change the setting.
Input a Plot Nesting maximum length between 21 and 2438 centimeters
using the numeric keypad.
Press the Enter key to confirm the choice and the Exit key to return to
the PLOT NESTING menu.
the PLOT NESTING menu.
• Press on the Control Panel to put the printer back on-line.