Xerox Phaser 3600 Leaflet

 Configure IP Settings and IP Filtering

1

1

IPv6 Supplement

Configure IP Settings

This procedure enables the System Administrator to enable and configure IPv6 and IPv6 Filtering on 
some Xerox WorkCentre/Phaser mono printers and Xerox WorkCentre/Phaser mono MFP products via 
CentreWare Internet Services (CWIS).

Check the Xerox Support Website 

www.support.xerox.com

 for your Xerox product to determine if it 

supports IPv6, and whether the firmware level loaded on your Xerox product supports IPv6. Print a 
Configuration Report from your Xerox device (under the Reports menu) and check the version of the 
firmware. If it is less than the firmware listed on the website then you need to download new firmware 
to enable IPv6 capabilities.

1.

At your Workstation, open the Web browser and enter the TCP/IP Address of the machine in the 
Address bar.

2.

Press [Enter].

3.

Click on the [Properties] tab.

4.

Click on the [Connectivity] link.

5.

Click on the [Protocols] link.

6.

Select [TCP/IP] from the directory tree.

7.

Scroll down the page to TCP/IPv6 area, for the Protocol click the [Enabled]checkbox.

Stateless Addresses

The Link-Local Address is automatically populated.

Default DHCPv6 (Dynamic Host Configuration Protocol) Settings

The device performs auto-address DHCPv6 configuration every time it powers up. This is used for 
neighbour discovery and address resolution on the local IPv6 subnet.

However, you can choose to use manual configuration, automatic configuration or a combination of 
automatic and manual configuration.

8.

Select one of the following options:

•

[Use DHCP as directed by a router] - this option is fully automatic. The DHCPv6 Address will 
be obtained and displayed on the screen.

•

[Always Enable DHCP] - this option is fully automatic. The DHCPv6 Address will be obtained 
and displayed on the screen.