Xerox Phaser 3400 Installation Guide
Network Guide
3
Connecting Your Printer to a Network
Connecting Your Printer to a Network
Setting up an Ethernet connection to a Macintosh
or PC
Requirements
■
Two RJ-45, twisted-pair, Ethernet 10BaseT or 100BaseT cables
■
An Ethernet hub
The Phaser 3400 printer's Ethernet interface conforms to IEEE 802.3 and Ethernet II
standards. Use twisted pair (10BaseT or 100BaseT) connections. Thick coax (10Base5) and
thin coax (10Base2) connections require adapters; contact your dealer to obtain adapters,
cables, and terminators.
standards. Use twisted pair (10BaseT or 100BaseT) connections. Thick coax (10Base5) and
thin coax (10Base2) connections require adapters; contact your dealer to obtain adapters,
cables, and terminators.
Caution
To avoid damaging the Ethernet interface, turn off the printer before making any
Ethernet connections.
Ethernet connections.
Procedure
1.
If the printer is on, turn it off.
2.
Connect one end of an Ethernet cable to the Ethernet port on the printer.
3.
Connect the other end of the cable to the hub. (Do not connect the cable to a port on
the hub labeled Uplink).
the hub labeled Uplink).
4.
Turn on the printer.
5.
Refer to the configuration instructions for your environment.