Xerox Phaser 3600 User Guide
8.5
<Maintenance>
Cautions
• If toner gets on your clothing, wipe it off with a dry cloth and
wash clothing in cold water. Hot water sets toner into fabric.
• To prevent damage to the print cartridge, do not expose it to
light for more than a few minutes. Cover it with a piece of
paper, if necessary.
paper, if necessary.
• Do not touch the green surface underside of the print
cartridgeprint cartridge. Use the handle on the cartridge to
avoid touching this area.
avoid touching this area.
5
At the end of the print cartridge, the sealing tape is located.
Carefully pull the tape out of the cartridge and discard it.
Carefully pull the tape out of the cartridge and discard it.
Notes
• The sealing tape should be longer than 60 cm when correctly
removed.
• Holding the print cartridge, pull the sealing tape straight to
remove it from the cartridge. Be careful not to cut the tape. If
this happens, you cannot use the print cartridge.
this happens, you cannot use the print cartridge.
• Refer to the helpful pictures on the cartridge wrapping paper.
6
There is a flexible plastic holder. Remove the holder from the print
cartridge.
cartridge.
7
Hold the print cartridge by the handle and slowly insert the
cartridge into the opening in the printer.
cartridge into the opening in the printer.
8
Tabs on the sides of the cartridge and corresponding grooves
within the printer will guide the cartridge into the correct position
until it locks into place completely.
within the printer will guide the cartridge into the correct position
until it locks into place completely.
9
Close the top cover. Make sure that the cover is securely closed.
Clearing the Toner Low Replace Toner message
When the Toner Low Replace Toner message appears you can
configure the machine so it does not display the message.
configure the machine so it does not display the message.
1
Press Menu until System Setup appears on the bottom line of the
display and press OK.
display and press OK.
2
Press the Scroll buttons until Maintenance appears and press OK.
3
Press the Scroll buttons until CLR Empty Msg. appears and press
OK.
OK.
4
Select On and press OK.
5
Now the Toner Low Replace Toner message does not appear but
the Replace Toner message will remain for reminding you that a
new cartridge needs to be installed for quality.
the Replace Toner message will remain for reminding you that a
new cartridge needs to be installed for quality.
Caution
Once you have selected On, this setting will be permanently
written to the memory of the cartridge, and this menu item will
be removed from the Maintenance menu.
written to the memory of the cartridge, and this menu item will
be removed from the Maintenance menu.