Xerox FlowPort Support & Software Installation Guide

FlowPort System Requirements

1–4

❖

Xerox FlowPort Installation and Setup Guide

Windows NT or Windows 2000 Server

Microsoft Windows NT 4.0 Server with Service Pack 4,

5, or 6 (SP 6 is recommended for optimum
performance)

Microsoft Windows 2000 Server
Pentium II, III or Pentium Pro, 200 MHz or faster
128 MB RAM
420 MB free disk space
200-400 MB virtual memory
TCP/IP-enabled
Three IP ports: 21 and 25 required, 80 recommended
Domain Naming System (DNS) host name and static

IP address assigned:

host name: _____________________________________

IP address: ______________________________________

Note: To look up the IP address in a DOS
window—enter the command: ipconfig /all

Caution: Be sure to use the DNS hostname rather
than Windows NT networking name.

To verify that the DNS hostname is correct, access the
FlowPort server in a Web browser. You can use either the
IP address or the DNS hostname of the machine on
which the FlowPort server is installed.

If using the hostname, verify that it is the DNS
hostname rather than a Windows NT networking name.
(The machine may be displayed in the Windows
Network Neighborhood under an NT networking name,
which cannot be used to communicate with the
FlowPort server.) Perform the following steps to confirm
that the name is registered under DNS on the server.