Xerox DigiPath Professional Production Software Support & Software Administrator's Guide
H
ARDWARE
MAINTENANCE
X
EROX
D
IGI
P
ATH
P
RODUCTION
S
OFTWARE
4-4
S
YSTEM
A
DMINISTRATOR
G
UIDE
6. Before moving the scanner to its new location, follow the
same procedures for the initial installation to make sure the
surface on which the scanner will be placed is level.
surface on which the scanner will be placed is level.
7. Move the scanner to its new location.
8. Remove the packing screws from the scanner.
9. Reinstall the document handler on top of the scanner.
10. Plug the scanner power cord into an acceptable power
source and reconnect the SCSI cable to the scanner.
NOTE: Make sure the PC and scanner are off before
connecting the SCSI cable.
connecting the SCSI cable.
11. Perform the scanner registration procedure found in the
following section.
Registering the scanner
4
Register the scanner every time you remove or replace the
document handler, or if images appear shifted off the page after
scanning.
document handler, or if images appear shifted off the page after
scanning.
When you register the scanner, the parameters for scanning are
captured. The scanner identifies the position of the registration
documents, compares that position to the document, and makes
the necessary adjustment.
captured. The scanner identifies the position of the registration
documents, compares that position to the document, and makes
the necessary adjustment.
To register the scanner, you need ten registration documents,
part number 82E8371. These documents have an X in the upper
right and lower right corners of the page, and they come in an
envelope with your DigiPath software setup.
part number 82E8371. These documents have an X in the upper
right and lower right corners of the page, and they come in an
envelope with your DigiPath software setup.
If an error occurs during registration, acknowledge the error and
begin the process again. If you continue to have trouble, call
your Xerox representative for assistance.
begin the process again. If you continue to have trouble, call
your Xerox representative for assistance.
NOTE: If you have a document handler attached to your
scanner, register both the document glass and the document
handler.
scanner, register both the document glass and the document
handler.
The registration process lasts approximately 10 seconds for the
document glass and approximately 30 seconds for the document
handler.
document glass and approximately 30 seconds for the document
handler.
E
E