Xerox ColorQube 9201/9202/9203 Administrator's Guide

Device Connection and Quick Setup

Xerox ColorQube™ 9201/9202/9203
System Administrator Guide

12

Settings, to enable use of the device's web user interface for network and options configuration. If 
necessary, reset TCP/IP addressing (including DHCP and DNS settings) and enable HTTP as follows:

1.

At the device and press the <Log In/Out> button to enter the Tools pathway.

2.

Enter the Administrator’s User Name [admin], touch [Next], enter the Password [1111], then 
touch [Enter].
Tip: This password can be changed by following the steps provided in the Administrator Tools 
topic in the General Setup section of this guide.

3.

Press the <Machine Status> button, and then the [Tools] tab.

4.

Wait for the screen to refresh, touch [Network Settings], touch [Advanced], if a warning message 
appears, touch [Continue].

5.

Touch the [HTTP Settings] button, touch [Enable], touch [Save], then touch [Close] to return to 
the Network Setting screen.

6.

Touch [TCP/IP Settings].

7.

Configure TCP/IP settings, including DHCP (Dynamic Addressing) and DNS, touch [Save], touch 
the [Close] button to return to the Network Setting screen.

Note:

This device supports IPv6 addressing, with an automatically-built Link Local Address for 

broadcasting to routers that can supply the network-layer configuration parameters. See 

When your device is configured with an IP address and HTTP is enabled, you can configure network 
information from your web browser via Internet Services. Enter the IP address of the device in your web 
browser to access Internet Services.