Zanussi ZWI71401WA User Manual

The spin phase does not

operate or the washing cy-

cle lasts longer than usual-

ly.

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the filter, if nec-

essary. Refer to 'Care and cleaning'.

• Adjust manually the items in the tub and start the spin phase again.

This problem may be caused by balance problems.

There is water on the floor.

• Make sure that the couplings of the water hoses are tight and there

is not water leakages.

• Make sure that the drain hose have no damages.

• Make sure you use the correct detergent and the correct quantity of

it.

• Make sure you have replaced the emergency emptying cap into the

filter

• Make sure you have properly screwed the filter in after cleaning.

You cannot open the appli-

ance door.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the drum.

The appliance makes an

unusual noise.

• Make sure the levelling of the appliance is correct. Refer to 'Installa-

tion'.

• Make sure that the packaging and/or the transit bolts are removed.

Refer to 'Installation'.

• Add more laundry in the drum. The load may be too small.

The washing results are

not satisfactory.

• Increase the detergent quantity or use a different detergent.

• Use special products to remove the stubborn stains before you

wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

You cannot set an option.

• Make sure that you press only the wanted button(s).

After the check, activate the appliance. The

programme continues from the point of interruption.
If the problem occurs again, contact the Authorised

Service Centre.
If the display shows other alarm codes. Deactivate

and activate the appliance. If the problem

continues, contact the Service.

SERVICE
We recommend the use of original spare parts.
When contacting the Authorised Service Centre,

make sure that these data are available. You can

find the information on the rating plate: model, PNC

and Serial Number. (Mod., Prod. No., Ser. No.)

WARNING! Refer to Safety chapters.

Remove all transit bolts and packing

before you use the appliance. You are

advised to keep all transit devices so t

hat they can be refitted if the appliance

ever has to be transported again.

• After removing all the

packaging, carefully

lay the appliance on

it’s back to remove

the polystyrene base

from the bottom.