Zanussi ZWI71401WA User Manual

• Remove the power

supply cable and the

draining hose from the

hose holders on the

rear of the appliance.

• Unscrew the three

bolts.

• Slide out the relevant

plastic spacers.

• Remove the polystyr-

ene block fitted on the

door seal. Pull out all

items from the drum.

• Fill the smaller upper

hole and the two large

ones with the plastic

plug caps supplied in

the bag with the User

Manual.

POSITIONNING
• Install the machine on a flat hard floor. Make

sure that air circulation around the appliance is

not impeded by carpets, rugs etc.

• Check that the machine does not touch the wall

or other kitchen units.

• Level the appliance by

raising or lowering the

feet.

• The feet may be tight

to adjust as they in-

corporate a self lock-

ing nut, but the appli-

ance MUST be level

and stable.

• If necessary, check the setting with a spirit level.

Any necessary adjustment can be made with a

spanner.

• After having levelled

the appliance, tighten

the lock nuts.

• Accurate levelling pre-

vents vibration, noise

and displacement of

the appliance during

operation.

Never place cardboard, wood or

similar materials under the appliance

to compensate for any unevenness in

the floor.

WATER INLET
• The inlet hose is supplied with the appliance

and can been found inside the appliance drum.

• Do not use the hose from your previous

appliance to connect to the water supply.

This appliance must be connected toa

cold water supply.

45˚

35˚

• Connect the hose

with the angled con-

nection to the ma-

chine. Do not place

the inlet hose down-

wards.

• Angle the hose to the

left or right depending

on the position of your

water tap.

• Set the hose correctly by loosening the ring nut.

After positioning the inlet hose, be sure to tight-

en the ring nut again to prevent leaks.