Bosch TES 51521 RW VeroCafe LattePro User Manual

TES515.. | 7/2014

The aromaDouble Shot function is activated 

with the following settings: 

Fill the appropriate container using only 

pure, 

cold, uncarbonated water and only 

roasted beans (preferably espresso or 

coffee bean blends for fully automatic coffee 

machines). Do not use coffee beans that 

have been glazed, caramelised or treated 

with other additives containing sugar, since 

they will block the brewing unit. 

The water hardness setting can be adjusted 

on this appliance. The factory default  setting 

for the water hardness is 4. Check the 

 water hardness with the enclosed test strip.

If the check reveals a value other than 4, 

change the setting on the appliance accord-

ingly after switching on (see “Menu settings” 
Water hardness

).

 

● Remove the protective film.

 

● Place the fully automatic espresso 

 machine on a flat, water-resistant surface 

that can take its weight. Make sure that 

the machine’s ventilation slots  remain 

unobstructured.

Important: Only use the appliance in 

frost-free rooms. If the appliance has been 

transported or stored at temperatures below 

0 °C, wait at least 3 hours before operation.

 

● Pull the power cord out of the storage 

compartment (21) and plug in. Adjust the 

length of the cable by pushing it back in 

or pulling it out. The easiest way to do 

this is to place the appliance so that its 

back is flush with the edge of the counter 

and either pull the cable 

downward or 

push it 

upward.

 

● Install the milk frother. Operate the 

machine only after the milk frother (6) has 

been fully assembled and installed.  

 

● Lift the lid of the water tank (18).

 

● Remove and rinse the water tank (17) 

and fill it with fresh cold water.  

Do not fill above the 

max mark.

 

● Replace the water tank (17) and push it 

firmly downward into place.

 

● Close the lid of the water tank (18) again. 

 

● Fill the bean container (1) with coffee 

beans (for preparation using ground 

coffee, see “Preparation using 

ground coffee”).

 

● Press the power switch 

O / I (9). The 

display (16) shows the menu for setting 

the display language.

 

● Select the required display language with 

the upper rotary knob (15). 

 

● Place a receptacle under outlet (6a).

 

● Press the 

start button (10). 

The  language you selected is saved.

The appliance heats up and rinses. Some 

water will run out of the coffee outlet.  

When the drink selection menu is shown in 

the display, the appliance is ready for use.