Cisco Cisco Expressway
Maintenance routine
Creating a System Backup
To create a backup of Expressway system data:
1. Go to
Maintenance > Backup and restore
.
2. Optionally, enter an Encryption password with which to encrypt the backup file.
If a password is specified, the same password will be required to restore the file.
3. Click Create system backup file.
4. After the backup file has been prepared, a pop-up window appears and prompts you to save the file (the
exact wording depends on your browser). The default name is in the format:
<software version>_<hardware serial number>_<date>_<time>_backup.tar.gz.
(The file extension is normally .tar.gz.enc if an encryption password is specified. However, if you use
Internet Explorer to create an encrypted backup file, the filename extension will be .tar.gz.gz by default.
These different filename extensions have no operational impact; you can create and restore encrypted
backup files using any supported browser.)
The preparation of the system backup file may take several minutes. Do not navigate away from this
page while the file is being prepared.
<software version>_<hardware serial number>_<date>_<time>_backup.tar.gz.
(The file extension is normally .tar.gz.enc if an encryption password is specified. However, if you use
Internet Explorer to create an encrypted backup file, the filename extension will be .tar.gz.gz by default.
These different filename extensions have no operational impact; you can create and restore encrypted
backup files using any supported browser.)
The preparation of the system backup file may take several minutes. Do not navigate away from this
page while the file is being prepared.
5. Save the file to a designated location.
Log files are not included in the system backup file.
Cisco Expressway Basic Configuration Deployment Guide (X8.6)
Page 28 of 57
Maintenance routine