Cisco Cisco Prime Infrastructure 1.3 Release Notes

Patch successfully installed

pnp-server/admin# 

Execute the pnp setup command to reconfigure the Plug and Play standalone server and start the 
plug and play process.

This section lists the open and resolved caveats for Cisco Prime Infrastructure Release 1.2.1.8: 

CSCud61403

Symptom: An error message is displayed during the Plug and Play standalone server setup.

Condition: During the Plug and Play standalone server setup, when you run the pnp setup 
command, the Plug and Play Gateway on the standalone server tries to disable the local Plug and 
Play Gateway on Cisco Prime Infrastructure. This results in the Plug and Play Gateway in the 
standalone server not receiving the correct CLIs from Cisco Prime Infrastructue, and the following 
error message being displayed: 

Attempting to disable the local PnP Gateway in Prime Infrastructure Machine 

10.104.105.170

Enter the username to login to the Prime Infrastructure Machine: [admin] 

Enter the password to login to the Prime Infrastructure Machine: 

Unknown error <ncs pnp disable

Workaround: Ignore the error message.

CSCuc47341

Symptom: The configuration CLI template fails on Cisco Prime Infrastructure even if the CLIs are 
pushed to the device.

Condition: When Cisco Prime Infrastructure deploys the configuration CLI template, in some 
cases, when the device displays warning messages, these warning messages are treated as failure by 
Cisco Prime Infrastructure.

Workaround: When you find that the configuration CLI template has failed on Cisco Prime 
Infrastructure, check the ifm_pnp logs for the actual cause of the failure. If the logs do not show any 
invalid CLI strings and the warning message (from the device) can be viewed in the logs, the 

config 

failure

 status message that is displayed on Cisco Prime Infrastructure can be ignored.