Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Troubleshooting Guide
Replace the ML Series Card for Cisco ONS 15454
Document ID: 66131
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Topology
Replace One ML Series Card
Related Information
Prerequisites
Requirements
Components Used
Conventions
Topology
Replace One ML Series Card
Related Information
Introduction
This document describes the procedure to replace a Cisco Multi−Layer (ML) Series card for the ONS 15454
platform.
platform.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15454
•
Cisco ONS 15454 ML−Series Ethernet Cards
•
Cisco IOS® Software
•
Bridging and IP Routing
•
Packet−over−SONET (POS)
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ONS 15454 that runs Cisco ONS Release 4.6.2
•
ML (bundled as part of the ONS 4.6.2 release) that runs Cisco IOS Software 12.1(20)EO1
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Topology
This document uses a lab setup with four ONS 15454 nodes, namely, Studio Node 1, Studio Node 2, Studio
Node 3 and Studio Node 4 (see Figure 1). These four nodes form one OC48 Unidirectional Path Switched
Node 3 and Studio Node 4 (see Figure 1). These four nodes form one OC48 Unidirectional Path Switched