Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Installation Guide

Page of 14
 
Corporate Headquarters:
Copyright © 2003 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Upgrading Cisco ONS 15454 Release 3.0.x to 3.0.3 
Using the TCC+ Card
Introduction
This document explains how to upgrade Cisco ONS 15454's Cisco Transport Controller (CTC) software 
from Release 3.0.x to Release 3.0.3 using the Timing, Communications, and Control + (TCC+) card.
Before beginning, write down the following information about your site; the data will be useful during 
and after the upgrade: Date, Street Address, Site Phone Number, and Dial Up Number.
Caution
Read each procedure before you begin the upgrade.
Caution
This procedure is only supported for Release 3.0.x.  If you wish to upgrade from Releases 2.2.0 – 2.2.2, 
use the procedures in Upgrading Cisco ONS 15454 Release 2.2.x to 3.0.3 Using the TCC+ Card. If you 
wish to upgrade from a release prior to Release 2.2.0, you must call the Technical Assistance Center 
(TAC) at 877 323-7368 for assistance.
Note
Procedures in this document are to be performed in consecutive order unless otherwise noted. In general, 
you are not done with a procedure until you have completed it for each node you are upgrading, and you 
are not done with the upgrade until you have completed each procedure that applies to your network. If 
you are new to upgrading the ONS 15454, you may wish to check off each procedure on your printed 
copy of this document as you complete it.