Cisco Cisco Unified MeetingPlace Audio Server Installation Guide

In the Server tab, do the following:

•

For 

, choose SLIP

•

For 

, make sure the checkbox is selected.

•

Click the 

 button to configure TCP/IP.

In the SLIP TCP/IP Settings dialog box, do the following, then click 

.

•

Make sure 

 is set to 198.207.208.242

•

Make sure 

and 

 are cleared

•

Keep 

 at 1006

In the New Phonebook Entry dialog box, click 

.

After configuring the dialup networking connection, you only need to 
select the phonebook entry that corresponds to your MeetingPlace server.

After you are connected to the MeetingPlace server, you can start your 
MeetingTime client.

Enter your user ID and password. For 

, enter: 

198.207.208.241

. 

Using this configuration, you can connect to the MeetingPlace using the 
MeetingTime Client through the modem connection. However, you cannot 
append or retrieve any attachment when connected using this method.

You can also connect a computer directly to the MeetingPlace server with a 
crossover LAN cable. (You can purchase an Ethernet 10 Base-T/100Base-TX 
crossover cable in most electronics stores.) 

To construct an Ethernet cable, instead of purchasing one, use the following 
table for wiring information.

If your MeetingPlace server is connected to the LAN, and you want to access 
the MeetingPlace server using the crossover cable while network connectivity 
is down, do the following:

Unplug the Ethernet cable from the back of the MeetingPlace server.

Connect the crossover cable in its place.

Reconnect the LAN cable after the network outage is resolved.

1

3

2

6

3

1

6

2