Cisco Cisco Unified MeetingPlace Audio Server Installation Guide
E-2 Administering Cisco MeetingPlace during network outage
MeetingPlace Audio Server Installation Planning Guide
Latitude Communications
4.
In the Server tab, do the following:
•
For
Dial-up server type
, choose SLIP
•
For
TCP/IP
, make sure the checkbox is selected.
•
Click the
TCP/IP Settings
button to configure TCP/IP.
5.
In the SLIP TCP/IP Settings dialog box, do the following, then click
OK
.
•
Make sure
IP address
is set to 198.207.208.242
•
Make sure
Force IP header compression
and
Use default gateway on
remote network
are cleared
•
Keep
Frame size
at 1006
6.
In the New Phonebook Entry dialog box, click
OK
.
After configuring the dialup networking connection, you only need to
select the phonebook entry that corresponds to your MeetingPlace server.
select the phonebook entry that corresponds to your MeetingPlace server.
After you are connected to the MeetingPlace server, you can start your
MeetingTime client.
MeetingTime client.
7.
Enter your user ID and password. For
Address
, enter:
198.207.208.241
.
Using this configuration, you can connect to the MeetingPlace using the
MeetingTime Client through the modem connection. However, you cannot
append or retrieve any attachment when connected using this method.
MeetingTime Client through the modem connection. However, you cannot
append or retrieve any attachment when connected using this method.
Administering MeetingPlace using a crossover LAN
cable connection
cable connection
You can also connect a computer directly to the MeetingPlace server with a
crossover LAN cable. (You can purchase an Ethernet 10 Base-T/100Base-TX
crossover cable in most electronics stores.)
crossover LAN cable. (You can purchase an Ethernet 10 Base-T/100Base-TX
crossover cable in most electronics stores.)
To construct an Ethernet cable, instead of purchasing one, use the following
table for wiring information.
table for wiring information.
If your MeetingPlace server is connected to the LAN, and you want to access
the MeetingPlace server using the crossover cable while network connectivity
is down, do the following:
the MeetingPlace server using the crossover cable while network connectivity
is down, do the following:
1.
Unplug the Ethernet cable from the back of the MeetingPlace server.
2.
Connect the crossover cable in its place.
3.
Reconnect the LAN cable after the network outage is resolved.
Pin
Pin
1
3
2
6
3
1
6
2