Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
7-11
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 7 Installing a Shadow Server
Restarting the shadow server
Step 7
Verify that all values are accurate.
Step 8
Verify the
Max Recording Space (min.)
field is set appropriately for the current configuration.
Languages confirmation
Verify that all languages installed on the primary server are also installed on the shadow server.
Gateway routing
How you configure the gateway routing depends if you have a set of backup gateway machines.
•
With a set of backup gateway machines. The gateways must be installed and connected before
bringing the shadow server online configured as a shadow server. The backup gateways need to be
set up and connected while the shadow server is in standalone server mode. Refer to the appropriate
MeetingPlace Audio Server 5.2 System Manager’s Guide for gateway installation procedures.
bringing the shadow server online configured as a shadow server. The backup gateways need to be
set up and connected while the shadow server is in standalone server mode. Refer to the appropriate
MeetingPlace Audio Server 5.2 System Manager’s Guide for gateway installation procedures.
When the system is converted to a shadow server, the gateways are down attempting to connect to
the server. Once the shadow server is brought into service as the primary server, the gateways
reconnect.
the server. Once the shadow server is brought into service as the primary server, the gateways
reconnect.
•
Without a set of backup gateway machines. The customer must correctly configure his network such
that if the primary server goes down, the TCP requests are re-routed to the shadow server.
that if the primary server goes down, the TCP requests are re-routed to the shadow server.
Other considerations
•
FlexMenus. If the primary server is configured with FlexMenus, the shadow server must also be
configured with FlexMenus before converting the system to a shadow server.
configured with FlexMenus before converting the system to a shadow server.
•
Custom prompts. If the primary server is configured with custom prompts, the shadow server must
also be configured with custom prompts before converting the system to a shadow server.
also be configured with custom prompts before converting the system to a shadow server.
•
Translation tables. The translation tables for the primary server are not replicated. You need to
configure the translation table on the shadow server to match the primary server as needed. However,
the translation tables may be different, especially if the shadow server is in a different location.
configure the translation table on the shadow server to match the primary server as needed. However,
the translation tables may be different, especially if the shadow server is in a different location.
Restarting the shadow server
At this point, you must restart the shadow server.
Step 1
If not already connected, access the command line interface (CLI) by following the procedures in the
and
.
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
At the tech$ prompt, type
restart enable
and press Enter.
Step 4
Type y and press Enter to confirm that you want to restart the system.