Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-30
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Zero code
suppression
suppression
B8ZS
Specifies the zero code
suppression for the span.
Determined by the service
provider.
suppression for the span.
Determined by the service
provider.
We recommend using B8ZS
only.
only.
•
none
•
B8ZS
•
jammed bit
Timing
external
Specifies if MeetingPlace
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
should get clock timing from
the PBX/Central Office or if
timing is generated by
MeetingPlace.
At least one span should
always be designated external.
always be designated external.
•
internal
•
external (the span is
connected to the
public network or a
trusted system)
connected to the
public network or a
trusted system)
External sync
priority
priority
none.
The T1 span
connected to the
T1 Smart Blade
in slot 1, line A
gets sync priority
1, line B gets 2,
etc.
connected to the
T1 Smart Blade
in slot 1, line A
gets sync priority
1, line B gets 2,
etc.
Specifies the priority of the
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system
automatically switches
synchronization to the next
highest span. If a higher
priority span comes up, the
system automatically
synchronizes off of it.
spans that are set for external
timing. The system always
tries to synchronize from the
highest priority span. If the
synchronization span goes
down, the system
automatically switches
synchronization to the next
highest span. If a higher
priority span comes up, the
system automatically
synchronizes off of it.
•
1-255 (1 is the
highest, 255 is the
lowest)
highest, 255 is the
lowest)
•
never
Trunk [x]
Numbering is
done in order (1,
2, 3, etc.). For
example,
done in order (1,
2, 3, etc.). For
example,
Trunk [1]:port 0
Trunk [2]:port 1
Trunk [3]:port 2
Specifies which port in the
database is assigned to the
specific hardware trunk on the
card.
database is assigned to the
specific hardware trunk on the
card.
•
number
Remote loopback to
network
network
n
Specifies if the span should be
put into a loopback mode for
testing from the remote end.
put into a loopback mode for
testing from the remote end.
•
y = yes
•
n = no (normal
operation)
operation)
Internal data
loopback
loopback
n
Specifies if the span should
loop back locally for running
diagnostics.
loop back locally for running
diagnostics.
•
y = yes
•
n = no (normal
operation)
operation)
Port group
0
Specifies the number of the port
group.
group.
•
0 (T1 CAS)
•
1 (IP)
•
2 (E1)
•
3 (T1 PRI)
Active?
y (if you use a
blade to configure
T1)
blade to configure
T1)
Specifies if the port group is
active.
active.
•
y = yes
•
n = no
Table 4-5
Default T1 CAS Span Configuration (continued)
Parameter
Default
Explanation
Possible Values
X