Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual
4-33
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Figure 4-38 span Record Configuration
Step 5
Enter values as indicated by
. Press Enter after you enter each value and the next line appears.
If you exceed the number of ports configured by the factory, an error message appears.
Step 6
Press Enter. The “span” menu appears as in
Step 7
Type
2
and press Enter to configure another span or type
x
and press Enter when all spans have been
configured.
Note
This is the end of the
section. Proceed to
to complete configuration.
Configuring a T1 PRI system
This section explains how to configure Multi Access Blades and Smart Blades for a T1 PRI system.
Note
If this is part of a T1 PRI/IP mixed configuration, refer to the
. If this is part of a T1 CAS system, refer to the
. If this is part of an E1 system, refer to the
. If this is part of a pure IP system, refer to the
.
Enter command: 2
Enter DTI span record number [0..23] : 0
------------- UNIT 0 SPAN 0 --------------
--- To skip over a field, just press <cr> ---
Activate the DTI span? [y] :
Framing [ESF] : D4
Zero code suppression [ B8ZS] :
Timing [external] :
External sync priority [ 1] :
Trunk [ 1] [port 0] :
Trunk [ 2] [port 1] :
Trunk [ 3] [port 2] :
Trunk [22] [port 21] :
Trunk [23] [port 22] :
Trunk [24] [port 23] :
Remote loopback to network? [n] :
Internal data loopback? [n] :
Enter command: