Cisco Cisco Customer Voice Portal 8.0(1)

This entry matches the ringtone.tcl dial peer in the gateway
configuration. It provides the sound of the ringing phone
after you dial the exercise test number.

91> and 10.86.132.177(ingress
gateway IP address)

This entry matches the cvperror.tcl dial peer in the gateway
configuration. It provides error handling.

92> and 10.86.132.177 (ingress
gateway IP address)

This entry will match the VRU label you establish later in
ICM. It is used to pass incoming calls to ICM. The ">"

123456789> and 10.86.132.177
(ingress gateway IP address)

indicates any additional digits after the "123456789" and
is added because additional digits are added to the label by
ICM.

This entry identifies a set of phones that the Unified
Communications Manager can send the exercise test call

40> and 10.86.132.142 (Unified
Communications Manager)

to. In this test setup, you send the call to a phone with an
extension beginning with 40. The 40> entry will match any
phone number that begins with 40. The IP address should
be the Unified CM server you are using for this exercise.
If you are sending the call to a different phone number, use
that number instead of 40>.

Figure 40: Unified CVP Call Server - Configure for Comprehensive Exercise

Click Save &Deploy to accept the default values for the items in the other tabs, save the
configuration, and deploy the call server to the example installation. (You receive a message
that certain fields have changed. Click OK to continue.)

A successfully added to the network map message, similar to the following example, displays.

Figure 41: Unified CVP Operations Console - Call Server Successfully Added

Leave the Operations Console open for the next task.

Getting Started with Cisco Unified Customer Voice Portal Release 8.0(1)