Cisco Cisco Customer Voice Portal 8.0(1)
dial-peer voice 8 voip
service helloworld
description receives POTS call for helloworld and changes to VoIP
destination-pattern 8002221111
session target ipv4:<put gateway IP here>
incoming called-number 8002221111
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711ulaw
no vad
dial-peer voice 7 voip
service customhelloworld
description receives POTS call for customhelloworld and changes to VoIP
destination-pattern 7002221111
session target ipv4:<put gateway IP here>
incoming called-number 7002221111
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711ulaw
no vad
dial-peer voice 800 voip
description rx VoIP call from Call Mgr & requests helloworld from VXML Server
service helloworld
incoming called-number 8T
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711ulaw
no vad
dial-peer voice 700 voip
description rx VoIP call from Call Mgr & requests customhelloworld from VXML Server
service customhelloworld
incoming called-number 7T
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711ulaw
no vad
Step 7
Save your modified template file.
Copy the Configuration Changes to the Operations Console
In this task you bring the modified template into the Operations Console:
There are two ways to bring the template into the Operations Console:
•
You can copy the file to the system that is running the Operations Console, then use the Add
Template feature to browse to and add the template.
Template feature to browse to and add the template.
•
You can create a template in the Operations Console by copying an existing template, then
paste your configuration over the lines in the template copy to create a new version of the
copied template. This is the method used in the following steps.
paste your configuration over the lines in the template copy to create a new version of the
copied template. This is the method used in the following steps.
Step 1
Open the Operations Console you are using for this exercise and select: System > IOS Template
> IOS Template Management.
> IOS Template Management.
Step 2
Click the checkbox for any of the sample templates and click Copy.
Step 3
Provide a name and description for the new template. For example:
Getting Started with Cisco Unified Customer Voice Portal Release 8.0(1)
51
Chapter 6: Unified CVP VXML Server Standalone Call Flow Model Exercise (HelloWorld)
Configure Your Voice Gateway for VXML Server Calls