Cisco Cisco Prime Infrastructure 2.1 Installation Guide

If you are licensing Assurance, you must complete pre-installation tasks so that Assurance can monitor your network interfaces 
and services. See 

 for information about these tasks. These tasks are in addition to those 

covered in 

Prime Infrastructure with Assurance needs to collect data from your network devices using the exported data sources shown in 

. For each source, the table shows the devices that support this form of export, and the minimum version of IOS or other 

software that must be running on the device in order to export the data.

Use 

 to verify that your network devices and their software are compatible with the type of data sources Prime 

Infrastructure uses. If needed, upgrade your hardware or software. Note that each software version given is a minimum. Your 
devices can run any later version of the same software or IOS release train.

You may also need to make changes to ensure that Prime Infrastructure can collect data using SNMP, as explained in 

Before installing, you should enable the supported devices shown in 

 to provide Prime Infrastructure with fault, 

application, and performance data, and ensure that time and date information are consistent across your network. The following 
topics provide guidelines on how to do this.

Catalyst 3750-X / 
3560-X

15.0(1)SE

IP base or IP services 
feature set and 
equipped with the 
network services 
module.

TCP and UDP traffic

See the “Configuring NetFlow on Catalyst 3000, 
4000, and 6000 Family of Switches” section in the 

Catalyst 3850

15.0(1)EX

TCP and UDP traffic, 
Voice & Video

To configure TCP and UDP traffic, see the 
“Configuring NetFlow on Catalyst 3000, 4000, and 
6000 Family of Switches” section in the 

To configure Voice & Video, use this CLI template:

Catalyst 4500

15.0(1)XO and 
15.0(2)

TCP and UDP traffic, 
Voice & Video

To configure TCP and UDP traffic, see the 
“Configuring NetFlow on Catalyst 3000, 4000, and 
6000 Family of Switches” section in the 

To configure Voice & Video, use this CLI template: