Cisco Cisco Voice Interface Cards Installation Guide
Connecting Cisco 2-Port E&M Voice Interface Cards
2-Port E&M Voice Interface Cards
2
Cisco IOS Release 12.4(20)T
OL-14874-01
Figure 1
Cisco 2-Port E&M VIC Front Panel (VIC3-2E/M)
2-Port E&M Voice Interface Card LEDs
The E&M voice interface card has one IN USE LED for each port.
LEDs.
Supported Platforms
This Cisco voice interface card (VIC3-2E/M) is supported on the following Cisco routers:
•
Cisco 2800 series routers, including the Cisco 2801, Cisco 2811, Cisco 2821, and Cisco 2851
•
Cisco 3800 series routers, including the Cisco 3825 and Cisco 3845
•
Cisco IAD2430 series routers
•
Cisco 2900 series routers
•
Cisco 3900 series routers
Note
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at
support. Access Cisco Feature Navigator at
. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
the login dialog box and follow the instructions that appear.
Prerequisites for Connecting 2-Port E&M Voice Interface Cards to a Network
Before connecting a VIC to the network, ensure that the VIC is installed in the router, the equipment is
properly grounded, and you have the proper cables for connecting the VIC to the network. This section
describes the preparation necessary before connecting a 2-port E&M VIC to the network.
properly grounded, and you have the proper cables for connecting the VIC to the network. This section
describes the preparation necessary before connecting a 2-port E&M VIC to the network.
230247
SEE MANUAL BEFORE INSTALLATION
VIC3-
2E/M
2E/M
IN USE
IN USE
1
0
LED
LED
Table 1
Cisco 2-Port E&M VIC LEDs
LED status
Description
Green
Monitored ports are active (have initialized without error).
Yellow
At least one monitored port is not ready.
Off
Monitored ports are not active or have failed to initialize.