Cisco Cisco VN 2900 Network Adaptation Interface Installation Guide
Serial Interface Cards
Serial High Speed WICs
6
Connecting Cisco AON Network Modules to the Network
Step 4
Connect one end of the appropriate serial cable to the connector on the card faceplate.
Step 5
Connect the other end of the cable to the appropriate type of equipment, as shown in
.
Figure 5
Connecting the Serial WAN Port to a Modem or DSU/CSU
Step 6
Turn on power to the router by pressing the power switch to the ON ( | ) position.
On the Cisco MWR 1941-DC router, turn on power to the router by turning ON the DC power source at
the circuit breaker.
the circuit breaker.
Step 7
Check that the CONN LED goes on, which indicates that the card’s serial port detects the WAN serial
connection.
connection.
Serial High Speed WICs
There are five Cisco serial high speed WICs (HWICs). This section describes the HWICs and tells how
to connect them to a network. It contains the following subsections:
to connect them to a network. It contains the following subsections:
•
•
•
•
•
•
•
•
•
SERIAL
Serial transition
cable
DSU/CSU or
other DCE
EIA/TIA-232, EIA/TIA-449, V.35,
X.21, or EIA-530 connector
41189
Synchronous serial
port (DB-60)
CONN LED
CONN