Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
The CMR is now permanently available and can be accessed at any time.
Differences from TelePresence Conductor-created conferences
A CMR is a conference on TelePresence Conductor that has been created by Cisco TMSPE.
A CMR template in Cisco TMSPE corresponds to a conference template and a conference alias on
TelePresence Conductor.
TelePresence Conductor.
Beware that:
n
Collaboration Meeting Room created using Cisco TMSPE cannot be modified in TelePresence Conductor.
n
Conferences templates and aliases created in TelePresence Conductor cannot be modified in Cisco
TMSPE.
TMSPE.
n
The "lecture" conference type is not supported with Collaboration Meeting Rooms.
Collaboration Meeting Room resource consumption
When you provision a CMR on TelePresence Conductor using Cisco TMSPE, TelePresence Conductor
reserves the resources for one participant with the defined quality level. When participants dial into the CMR
and resource optimization is enabled, TelePresence Conductor optimizes the resources so that only the
resources that are required are used on the conference bridge.
reserves the resources for one participant with the defined quality level. When participants dial into the CMR
and resource optimization is enabled, TelePresence Conductor optimizes the resources so that only the
resources that are required are used on the conference bridge.
However, the resources that were previously reserved are not freed up completely. The resources can be
used by additional participants dialing into the same CMR. But the reserved resources cannot be used for
other conferences. The conference bridge utilization on TelePresence Conductor shows the number of
resources reserved if this number is higher than the number of resources used.
used by additional participants dialing into the same CMR. But the reserved resources cannot be used for
other conferences. The conference bridge utilization on TelePresence Conductor shows the number of
resources reserved if this number is higher than the number of resources used.
Setting up Collaboration Meeting Room
Like Smart Scheduler, Collaboration Meeting Room can be used independently of device provisioning and
FindMe.
FindMe.
Before you start
Cisco TMSPE must be set up and enabled as described in this document:
n
n
TelePresence Conductor must be set up with one or more populated bridge pools and one or more Service
Preferences:
Preferences:
n
l
Omit the tasks to create conference templates, aliases, and auto-dialled participants on TelePresence
Conductor, as you will perform corresponding tasks on Cisco TMSPE instead.
Conductor, as you will perform corresponding tasks on Cisco TMSPE instead.
l
To support users creating auto-connected participants, ensure that you correctly configure the
rendezvous location:
rendezvous location:
Conference configuration > Locations >
Select location >
SIP trunk setting
for out-dial calls
.
n
The only supported bridge types are Cisco TelePresence Server and Cisco TelePresence MCU Series.
Cisco TelePresence Management Suite Provisioning Extension with Cisco VCS Deployment Guide (1.4)
Page 55 of 96
Deploying Collaboration Meeting Rooms