Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
4.
You can now pre-configure default settings to allow Cisco TMS to immediately start working with a basic network
configuration. The settings can be changed after installation.
If upgrading, values from the existing database are displayed.
configuration. The settings can be changed after installation.
If upgrading, values from the existing database are displayed.
Field label
Description
TMS Server IPv4
Address
Address
The IPv4 address of the local server.
TMS Server IPv6
Address
Address
The IPv6 address of the local server. If IPv6 is not enabled on the Windows Server, this
field can be left blank.
field can be left blank.
IP
Broadcast/Multicast
Addresses […]
Broadcast/Multicast
Addresses […]
The broadcast address(es) for the networks that Cisco TMS is to automatically search for
devices. (Systems that Cisco TMS discovers can be automatically added to Cisco TMS
with their management settings added.) Multiple broadcast addresses can be entered
separated by commas. Cisco TMS will search networks by sending a SNMP Discovery
packet to the supplied addresses. The default value will be the broadcast address of the
Cisco TMS server’s network.
devices. (Systems that Cisco TMS discovers can be automatically added to Cisco TMS
with their management settings added.) Multiple broadcast addresses can be entered
separated by commas. Cisco TMS will search networks by sending a SNMP Discovery
packet to the supplied addresses. The default value will be the broadcast address of the
Cisco TMS server’s network.
Note that the Windows SNMP Service is disabled by default for new installations.
Enable automatic
registration of
systems in TMS
registration of
systems in TMS
If enabled, systems Cisco TMS discovered on the network will automatically be added
into a folder in Cisco TMS and have their management settings configured. This setting
is disabled by default.
into a folder in Cisco TMS and have their management settings configured. This setting
is disabled by default.
Sender E-mail
Address
Address
The email address you wish to appear in the From field of messages sent by Cisco TMS.
Example:
Example:
videomanagement@example.com
.
SMTP Server
Address
Address
The network address of the SMTP server Cisco TMS will use to send email. Additional
authentication configuration settings can be set up post installation as needed.
authentication configuration settings can be set up post installation as needed.
5.
Click Next when done modifying the settings.
Cisco TMS then contacts the supplied SMTP server to verify the settings and warns you if it was not able to
contact the server.
Cisco TMS then contacts the supplied SMTP server to verify the settings and warns you if it was not able to
contact the server.
If this is a new installation, the IP/ISDN Zone screen will then be displayed.
Pre-configuring Zones and Setting Install Folder Location
Zones are a configuration concept used by Cisco TMS to route phone numbers and aliases when scheduling calls and
using phone books.
using phone books.
28
Cisco TelePresence Management Suite Installation and Upgrade Guide
Installing or Upgrading Cisco TMS