Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
Field label
Description
IP
Broadcast/Multicast
Addresses […]
Broadcast/Multicast
Addresses […]
The broadcast address(es) for the networks that Cisco TMS is to automatically search
for devices. (Systems that Cisco TMS discovers can be automatically added to Cisco
TMS with their management settings added.) Multiple broadcast addresses can be
entered separated by commas. Cisco TMS will search networks by sending a SNMP
Discovery packet to the supplied addresses. The default value will be the broadcast
address of the Cisco TMS server’s network.
for devices. (Systems that Cisco TMS discovers can be automatically added to Cisco
TMS with their management settings added.) Multiple broadcast addresses can be
entered separated by commas. Cisco TMS will search networks by sending a SNMP
Discovery packet to the supplied addresses. The default value will be the broadcast
address of the Cisco TMS server’s network.
Enable automatic
registration of
systems in TMS
registration of
systems in TMS
If enabled, systems Cisco TMS discovers on the network will automatically be added
into a folder in Cisco TMS and have their management settings configured. This setting
is disabled by default.
into a folder in Cisco TMS and have their management settings configured. This setting
is disabled by default.
Sender E-mail
Address
Address
The email address you wish to appear in the From field of messages sent by Cisco
TMS. Example: videomanagement@example.com.
TMS. Example: videomanagement@example.com.
SMTP Server
Address
Address
The network address of the SMTP server Cisco TMS will use to send email. Additional
authentication configuration settings can be set up post installation as needed.
authentication configuration settings can be set up post installation as needed.
5. Click Next when done modifying the settings.
Cisco TMS then contacts the supplied SMTP server to verify the settings and warns you if it was not able
to contact the server.
If this is a new installation, the
to contact the server.
If this is a new installation, the
IP/ISDN Zone
screen will then be displayed.
Pre-configuring zones and setting folder locations
Zones are a configuration concept used by Cisco TMS to route phone numbers and aliases when scheduling
calls and using phonebooks.
calls and using phonebooks.
The information entered during installation creates the first IP and ISDN zones in Cisco TMS, which will be
set as the initial default to allow a basic IP and ISDN network to operate after installation. Additional zones
and configurations must be added post installation for networks with multiple locations or more complex
elements.
set as the initial default to allow a basic IP and ISDN network to operate after installation. Additional zones
and configurations must be added post installation for networks with multiple locations or more complex
elements.
Cisco TelePresence Management Suite Installation and Upgrade Guide (14.4.1)
Page 23 of 55
Installing or upgrading Cisco TMS