Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Adding the Systems
Unified CM must be added to Cisco TMS before you can add the endpoints, following these steps:
1.
In
Systems > Navigator
go to the folder where you want to add the endpoints.
2.
Click Add Systems.
3.
Go to the
From List
tab.
4.
Click Unified CM.
5.
Select the endpoints you want to add.
6.
Click Next.
7.
Click Finish Adding Systems.
Adding an Unmanaged Bridge
Cisco TMS supports adding unsupported legacy and third party bridges (including Cisco TelePresence Multipoint
Switch) so they can be scheduled in conferences.
Switch) so they can be scheduled in conferences.
Prior to adding an unmanaged bridge to Cisco TMS, you must have created dedicated conferences for use with Cisco
TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence Multipoint Switch.
Refer to your bridge's documentation for details of how to configure these conferences.
TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence Multipoint Switch.
Refer to your bridge's documentation for details of how to configure these conferences.
To add an unmanaged bridge:
1.
Go to
Systems > Navigator
.
2.
Select the folder to which you want to add the bridge, and click Add Systems.
3.
Click the Add Unmanaged Bridge tab.
4.
Enter the following
Basic Settings
for the bridge (the other settings are optional):
a.
Name
b.
Max IP Bandwidth (kbps)
c.
Max Number of Video/Audio Calls:
•
If 0 is entered in Max Number of Audio Calls, the value set as the Max Number of Video Calls will
be the number of generic ports that can be used to book either video or audio participants.
be the number of generic ports that can be used to book either video or audio participants.
•
If anything higher than 0 is entered in Max Number of Audio Calls, video and audio calls are
counted separately and can not be used interchangeably.
counted separately and can not be used interchangeably.
d.
Check the Immersive checkbox if you want the bridge to be preferred in routing for conferences
including multiscreen participants.
including multiscreen participants.
5.
Add the
Bridge Addresses
:
a.
Select the number of bridge addresses up to a maximum of 25.
b.
Specify whether the bridge allows H.323, SIP or both.
c.
Specify the E.164 Alias, H.323 ID and/or SIP URI for pre-configured conference on the bridge.
These are the 'static meeting' addresses referred to above.
6.
Enter the
Location Settings
as appropriate.
Adding Unmanaged Endpoints
You can add a system as an unmanaged endpoint if the system type is not directly supported by Cisco TMS.
51
Cisco TelePresence Management Suite Administrator Guide
Adding and Managing Systems