Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
d.
In the Product Specific Configuration Layout section, enter a dummy email address in the Room Name
field.
This is a mandatory item but any email address can be used.
field.
This is a mandatory item but any email address can be used.
e.
In the Directory Number Information section of Directory Number Configuration, select Allow Control of
Device from CTI.
Device from CTI.
f.
Set the field SSH AdminLife to 0 to prevent the command-line interface password from expiring.
Cisco TMS uses this password to set up calls.
Cisco TMS uses this password to set up calls.
2.
For each IP phone device that is associated to a telepresence device, select Allow Control of Device from
CTI at the bottom of the Device Information section.
CTI at the bottom of the Device Information section.
Endpoints Running Collaboration Endpoint Software, TE, and TC Software
Endpoints running Collaboration Endpoint Software, TE, and TC software must already have been added to the
Unified CM as detailed in the Configuration guide for your version of Unified CM in
Unified CM as detailed in the Configuration guide for your version of Unified CM in
For each endpoint follow these steps in Unified CM:
1.
Go to Device > Phone and search for the device name corresponding to the telepresence endpoint.
2.
At the bottom of the Product Specific Configuration Layout section, ensure that Web Access and SSH
Access are set to Enabled.
Access are set to Enabled.
To change the username for endpoints, follow these steps:
1.
On the end point, add a username and password and change the password for the "admin" username.
2.
Go to TMS web interface > Systems > Navigator > Find endpoint > Settings.
3.
Click Force Refresh.
4.
Type a new username and password .
5.
Click Save.
Adding the Systems
Unified CM must be added to Cisco TMS before you can add the endpoints, following these steps:
1.
In Systems > Navigator go to the folder where you want to add the endpoints.
2.
Click Add Systems.
3.
Go to the From List tab.
4.
Click Unified CM.
5.
Select the endpoints you want to add.
6.
Click Next.
7.
Click Finish Adding Systems.
Adding an Unmanaged Bridge
Cisco TMS supports adding unsupported legacy and third party bridges (including Cisco TelePresence Multipoint
Switch) so they can be scheduled in conferences.
Switch) so they can be scheduled in conferences.
Prior to adding an unmanaged bridge to Cisco TMS, you must have created dedicated conferences for use with Cisco
TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence Multipoint Switch. Refer
to your bridge's documentation for details of how to configure these conferences.
TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence Multipoint Switch. Refer
to your bridge's documentation for details of how to configure these conferences.
To add an unmanaged bridge:
61
Cisco TelePresence Management Suite Administrator Guide
Adding and Managing Systems