Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Field
Description
Send Warning
When Auto
Attendant
Conferences
Exceed This
Duration (in
seconds)
When Auto
Attendant
Conferences
Exceed This
Duration (in
seconds)
A conference event is triggered in
Conference Control Center
when the duration of an MCU Auto
Attendant conference has exceeded the set time limit (in seconds). Set to 0 to disable (no event will
be triggered).
be triggered).
Automatic
MCU Failover
MCU Failover
■
Off: Cisco TMS will not initiate automatic MCU failover.
■
If conference start fails: Cisco TMS will automatically try another MCU if conference setup fails
during conference start.
during conference start.
■
If conference start or MCU polling fails: Cisco TMS will automatically try another MCU if
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this setting,
as Cisco TMS could disconnect all participants from a conference if the network connection to
the hosting MCU is lost for a short time, despite the conference having continued with no
problem. This setting is ignored for conferences hosted on a TelePresence Conductor.
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this setting,
as Cisco TMS could disconnect all participants from a conference if the network connection to
the hosting MCU is lost for a short time, despite the conference having continued with no
problem. This setting is ignored for conferences hosted on a TelePresence Conductor.
Note:
Automatic MCU Failover is only supported for scheduled conferences where the main par-
ticipant is an MCU or a TelePresence Conductor. It is not supported for cascaded conferences hosted
on direct managed MCUs.
on direct managed MCUs.
Automatic
MCU Failover
Threshold
(seconds after
first poll fail-
ure)
MCU Failover
Threshold
(seconds after
first poll fail-
ure)
Specify the number of seconds Cisco TMS will wait after the first poll failure before MCU failover is
executed.
executed.
Table 140 Settings in the Advanced section (continued)
WebEx Settings
In Cisco TMS:
Administrative Tools > Configuration > WebEx Settings
On the
WebEx Settings
page, you add WebEx sites to Cisco TMS and configure them.
Note that to be able to add WebEx in telepresence conferences, a WebEx Site, WebEx Username, and WebEx Pass-
word must also be set up for each conference owner in Cisco TMS, and your telepresence deployment must be set up to
support CMR Hybrid.
word must also be set up for each conference owner in Cisco TMS, and your telepresence deployment must be set up to
support CMR Hybrid.
■
For information on the user settings for WebEx, see
.
■
WebEx Configuration
Field
Description
Enable WebEx
■
Yes: Conferences can include Webex.
■
No: Conferences cannot include Webex.
Table 141 General WebEx settings for Cisco TMS
225
Cisco TelePresence Management Suite Administrator Guide
Administrative Tools