Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Field
Description
Automatic
MCU Failover
MCU Failover
n
Off: Cisco TMS will not initiate automatic MCU failover.
n
If conference start fails: Cisco TMS will automatically try another MCU if conference setup fails
during conference start.
during conference start.
n
If conference start or MCU polling fails: Cisco TMS will automatically try another MCU if
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this
setting, as Cisco TMS could disconnect all participants from a conference if the network
connection to the hosting MCU is lost for a short time, despite the conference having
continued with no problem. This setting is ignored for conferences hosted on a TelePresence
Conductor.
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this
setting, as Cisco TMS could disconnect all participants from a conference if the network
connection to the hosting MCU is lost for a short time, despite the conference having
continued with no problem. This setting is ignored for conferences hosted on a TelePresence
Conductor.
Note: Automatic MCU Failover is only supported for scheduled, non-cascaded MCU
conferences.
conferences.
Automatic
MCU Failover
Threshold
(seconds
after first poll
failure)
MCU Failover
Threshold
(seconds
after first poll
failure)
Specify the number of seconds Cisco TMS will wait after the first poll failure before MCU failover
is executed.
is executed.
Table 131: Settings in the Advanced section (continued)
WebEx Settings
In Cisco TMS:
Administrative Tools > Configuration > WebEx Settings
On the WebEx
Settings
page, you add WebEx sites to Cisco TMS and configure them.
Note that to be able to add WebEx in telepresence conferences, a WebEx Site, WebEx Username, and
WebEx Password must also be set up for each conference owner in Cisco TMS, and your telepresence
deployment must be set up to support WebEx Enabled TelePresence.
WebEx Password must also be set up for each conference owner in Cisco TMS, and your telepresence
deployment must be set up to support WebEx Enabled TelePresence.
n
n
WebEx Configuration
Field
Description
Enable WebEx
n
Yes: Conferences can include Webex.
n
No: Conferences cannot include Webex.
Add WebEx to All
Conferences
Conferences
n
Yes: All conferences will include WebEx by default. In the booking pages, the Include
WebEx Conference checkbox will by be checked, but can be cleared.
WebEx Conference checkbox will by be checked, but can be cleared.
n
No: This checkbox is by default cleared.
Table 132: General WebEx settings for Cisco TMS
Cisco TelePresence Management Suite Administrator Guide (14.4)
Page 260 of 331
Administrative Tools
Configuration