Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
1. Go to
Administrative Tools > Configuration > Network Settings
.
2. In the Event Notification section, add your address to E-mail Addresses to Receive System and
Network Notifications.
As systems on the network send HTTP events or are detected by the SNMP scanner service, they will now
be added to the specified folder, and you will be notified.
be added to the specified folder, and you will be notified.
To review the settings of these systems:
1. Go to
Systems > Navigator > [Name of your folder for discovered systems]
.
The default folder is Discovered Systems.
2. Review and adjust the settings for each system as desired.
3. Verify on the system's
Permissions
tab that new user groups will have permissions for the system.
Modify as required.
4. If desired, move the systems to a more permanent folder by selecting the system and clicking Move/Copy
in the folder listing.
Adding by IP addresses or DNS names
All types of infrastructure systems and endpoints can be added following the steps below. Note however that
endpoints registered to Unified CM must not be added in this way, see
endpoints registered to Unified CM must not be added in this way, see
To add a system:
1. Go to
Systems > Navigator
. Select a folder for the system.
2. Open Discovered Systems to verify that the system you are planning to add has not been added
automatically by Cisco TMS already.
l
l
If the system is not in the Discovered Systems folder, select the folder to which you want to add the
system.
system.
3. Click Add Systems.
4. Enter either the IP address, the DNS name, an IP range, or a comma-separated list of IP addresses
and/or DNS names.
Note that adding very large ranges slows down the system discovery scan process.
Note that adding very large ranges slows down the system discovery scan process.
5. Select Time Zone, IP Zone, and ISDN Zone for the system from the drop-down lists.
Cisco TelePresence Management Suite Administrator Guide (14.4)
Page 67 of 331
Adding and managing systems
Adding systems