Cisco Cisco Unified MeetingPlace for Microsoft Outlook Quick Setup Guide
1
Connecting the Cisco Unified MeetingPlace
Application Server to a Web Server
Application Server to a Web Server
Release 7.1
Revised: April 3, 2011 8:30 pm
Revised: April 3, 2011 8:30 pm
•
•
Adding or Editing a Web Server Connection
This task enables you to:
•
Configure the Gateway SIM connections between the Application Server and the Web Servers.
•
Add links to the Web Server from the Administration Center. The links appear in a drop-down menu
at the top of each Administration Center page.
at the top of each Administration Center page.
After you install and configure the Gateway SIM on the Web Server, the Gateway SIM automatically
registers the Web Server to the Application Server by opening an inbound connection from the Web
Server to port 5003 on the Application Server. Successfully registered Web Servers are automatically
configured on the
registers the Web Server to the Application Server by opening an inbound connection from the Web
Server to port 5003 on the Application Server. Successfully registered Web Servers are automatically
configured on the
, and links to those Web Servers appear in a drop-down menu at the
top of each Administration Center page.
If inbound connections are not allowed, such as in segmented meeting access (SMA) deployments or
when a firewall is in use, then you need to perform this task to enable the Application Server to open an
outbound “reverse connection” to port 5003 on the Web Server.
when a firewall is in use, then you need to perform this task to enable the Application Server to open an
outbound “reverse connection” to port 5003 on the Web Server.
Before You Begin
•
Install Gateway SIM and the Web Conferencing Server Software as described in the “
•
Configure Gateway SIM on the Web Server. See
in the
module.
•
From the Web Server, write down the following values on the Gateway SIM tab in the MeetingPlace
Gateways Configuration Utility:
Gateways Configuration Utility:
–
Unit
–
Installation Key (for reverse connection only)
–
Local IP Address (for reverse connection only)