Cisco Cisco MeetingTime Quick Setup Guide
1
Configuring SNMP on Cisco Unified
MeetingPlace
MeetingPlace
Release 7.1
Revised: April 3, 2011 8:31 pm
Revised: April 3, 2011 8:31 pm
•
•
•
About SNMP
•
You can use SNMP to monitor the Cisco Unified MeetingPlace application and the hardware for the
Application Server, Media Server, and Web Servers.
Application Server, Media Server, and Web Servers.
•
SNMP versions 1 and 2c are supported. SNMP version 3 is not supported.
•
All standard MIB II queries and a set of Cisco Unified MeetingPlace MIB traps are supported.
The MIB II queries include the Cisco Unified MeetingPlace Application Server name, location,
contact name, and statistics regarding the network interface.
contact name, and statistics regarding the network interface.
•
Traps are used to report events. See
Table 1
.
Each major and minor software notification includes an integer exception code and indicates which
software module and server reported the alarm. Normally, each alarm instance generates a separate
notification. In some cases, however, one specific incident could trigger multiple types of alarms.
software module and server reported the alarm. Normally, each alarm instance generates a separate
notification. In some cases, however, one specific incident could trigger multiple types of alarms.
Table 1
Cisco Unified MeetingPlace SNMP Traps
Name OID
1
Comment
Trap Types
Major Software Alarm
.1.3.6.1.4.1.7185.3.1.3.0.5
Generated any time Cisco Unified MeetingPlace reports a major
software alarm.
software alarm.
Minor Software Alarm
.1.3.6.1.4.1.7185.3.1.3.0.6
Generated any time Cisco Unified MeetingPlace reports a minor
hardware alarm.
hardware alarm.
Trap Message Content
SystemUpTime
1.3.6.1.2.1.1.3.0
Counter for actual Application Server uptime.
Trap Type
—
See