Cisco Cisco Unified MeetingPlace Audio Server Quick Setup Guide

Enter the following command to synchronize existing data from Node 2 and start database replication:

mp_replication switchON [-S -F from-sync] [-v]

Enter the following command to change Node 1 to active mode:

failoverUtil setServer active 

Using the hostname or IP address of the virtual eth0:0 interface, log in to the Administration Center of 
each node, and verify that the correct failover deployment mode (active or standby) appears at the top of 
the page.

If the Administration Center displays the wrong failover mode on either or both servers, then something 
may have interrupted the process initiated by the 

 command. To 

resolve this issue, see the 

 command description in the 

 module.

 module