Cisco Cisco TelePresence Management Suite (TMS) Version 15 Release Notes
New features in 14.1
Cisco TelePresence Management Suite 14.1.1 Software Release Notes
Page 5 of 21
As part of this consolidation, “Getting Started” is no longer a part of the Cisco TMS Installation Guide. All guidance on
setting up and configuring Cisco TMS is now found in the Administrator Guide and web help.
setting up and configuring Cisco TMS is now found in the Administrator Guide and web help.
Highlighting of fields in Systems > Navigator
When one or more settings for a managed system are incorrect, the incorrect settings are now highlighted in
Systems > Navigator
so that the administrator can easily identify which settings require attention.
The color scheme follows the Ticketing Service, where “Critical” and “Major” errors are marked in red, and “Warnings”
are marked in yellow.
are marked in yellow.
The
Systems > Navigator
window for a system with an incorrect management address.
Configurable database timeout value when upgrading Cisco TMS
The default database timeout value when upgrading Cisco TMS is 30 minutes. This value applies to each of the
installer’s internal database operations. For large deployments with years of historic call or system data, some of the
operations may need more than 30 minutes to complete.
installer’s internal database operations. For large deployments with years of historic call or system data, some of the
operations may need more than 30 minutes to complete.
The timeout value is now configurable via a command line option. To use a timeout value of 60 minutes, run the
installer using the command line:
installer using the command line:
TMS14.1.exe /z"sqltimeout 60"
Substitute 60 with a higher value if needed.
We recommend using the default value of 30 minutes, and only increasing the timeout value if the initial upgrade
attempt is failing.
attempt is failing.
Content Mode options on the Cisco TelePresence MCU
Cisco TMS now supports the new Content Mode settings introduced in version 4.3 of the Cisco TelePresence MCU.
In
Systems > Navigator >
select a Cisco TelePresence MCU on 4.3 or later
> Settings > Extended Settings
, the
Content Mode setting now has the following options: Disabled, Passthrough, Transcoded, and Hybrid.