Cisco Cisco TelePresence Management Suite (TMS) Version 15 Release Notes
Resolved issues
Cisco TelePresence Management Suite Release Notes Software Release Notes (14.6)
Page 53 of 79
Identifier
Description
CSCuh51719 Removed the option to Lock a conference that included a TelePresence Conductor in
Conference Control Center
. This functionality is not supported.
CSCui01713
Resolved the issue where the Cisco TMS Live Service was unable to resolve dial outs from a
TelePresence Conductor. This created duplicate entries in
TelePresence Conductor. This created duplicate entries in
Conference Control Center
(CCC),
and could also cause Cisco TMS to make the TelePresence Conductor dial out again although
the participant was already connected.
the participant was already connected.
CSCui24688
Added the Unified CM icon to the
Graphical Monitor
.
Systems Management
Identifier
Description
CSCui67809
Resolved the issue where Cisco TMS could instruct systems to dial out twice in One Button To
Push and No Connect conferences.
Push and No Connect conferences.
CSCui81432
Resolved the issue where it was not possible to upgrade a system that had a password using
Cisco TMS. This affected Cisco TelePresence E20 systems and systems running Cisco
TelePresence TC software versions earlier than TC 6.0.
Cisco TMS. This affected Cisco TelePresence E20 systems and systems running Cisco
TelePresence TC software versions earlier than TC 6.0.
CSCui66934
Resolved the issue for ISDN-capable systems in
Systems > Navigator >
select a system
>
Settings > TMS Scheduling Settings
where the text for the Allow Outgoing Telephone Dialing
checkbox was missing.
CSCui75542
Resolved the issue where the SNMP scan of systems did not occur at the time interval configured
in
in
Administrative Tools > Configuration > Network Settings > TMS Services >
System Alive-
Status Scan Interval (in seconds).
CSCui74636
Resolved the issue where a bridge behind a TelePresence Conductor that had been deleted but
not purged from Cisco TMS did not display the System(s) Managed by Cisco TelePresence
Conductor Not Found in TMS error.
not purged from Cisco TMS did not display the System(s) Managed by Cisco TelePresence
Conductor Not Found in TMS error.
CSCui74421
Resolved the issue where changing the H.323 and SIP username directly on an endpoint was not
reflected in Cisco TMS after performing a Force Refresh.
reflected in Cisco TMS after performing a Force Refresh.
CSCuh85852 Resolved the issue where Cisco TMS showed the following warning on a Cisco VCS: The number
of concurrent traversal calls has approached the licensed limit , when the ticket had previously
been acknowledged on both Cisco TMS and the Cisco VCS.
been acknowledged on both Cisco TMS and the Cisco VCS.
CSCui74362
Resolved the issue where a warning: #1255 - Incorrect SNMP CN was displayed when adding a
Cisco TelePresence MCU that had SNMP disabled to Cisco TMS. There should not have been a
warning in this case as these systems can be added to Cisco TMS with SNMP disabled.
Cisco TelePresence MCU that had SNMP disabled to Cisco TMS. There should not have been a
warning in this case as these systems can be added to Cisco TMS with SNMP disabled.
CSCui24563
Resolved the issue where messages sent from Cisco TMS that contained special characters were
not displayed on systems.
not displayed on systems.
CSCui74343
An error is now displayed if deleting or purging a system from Cisco TMS fails. Previously no error
was displayed.
was displayed.
CSCtr17122
Resolved the issue in
Systems > Navigator >
select a Cisco VCS
> Active Calls
where no data
was shown in the Duration column.
CSCuf57343
Resolved the issue where setting a SIP or H.323 password in
Systems > Navigator >
select a
system
> Settings > Edit Settings > Network Settings
did not set the password on the system.
CSCuh37146 Time zone fields are no longer displayed for Unified CM-registered systems in Cisco TMS as this
information cannot be read from the systems or from the Unified CM.