Cisco Cisco TelePresence Management Suite (TMS) Version 15 Release Notes
New features
Cisco TelePresence Management Suite Release Notes Software Release Notes (14.6.1)
Page 6 of 90
n
DeleteConferenceInstanceByExternaId
n
EndConferenceByExternalId
For a full overview of license key requirement, see Cisco TMSBA Programming Reference Guide.
Specifying recipients of booking email
It is now possible to specify email addresses that will receive booking confirmation and error notification
email messages when booking a conference using Cisco TMSBA. In the Cisco TMS web application this is
entered on the
email messages when booking a conference using Cisco TMSBA. In the Cisco TMS web application this is
entered on the
Conference Information
tab when booking a conference.
Reserved external source IDs
Using "TMS" and "TMS-ADHOC" as external source IDs is now reserved for Cisco TMS internal use. Cisco
TMSBA will throw an exception if either is used by another client.
TMSBA will throw an exception if either is used by another client.
New in 14.5
Added support for Unmanaged Bridges
Unsupported legacy and third party bridges (including Cisco TelePresence Multipoint Switch) can now be
added into Cisco TMS and scheduled in conferences.
added into Cisco TMS and scheduled in conferences.
These bridges are added from
Systems > Navigator > Add Systems > Add Unmanaged Bridge
. Once
added, they are displayed in
Systems > Navigator
, where you can view and edit a limited number of
settings, including limiting capacity by IP bandwidth and maximum number of concurrent calls.
You can also specify the number of audio and video ports as follows:
n
If 0 is entered in Max Number of Audio Calls, the value set as the Max Number of Video Calls will be
the number of generic ports that can be used to book either video or audio participants.
the number of generic ports that can be used to book either video or audio participants.
n
If anything higher than 0 is entered in Max Number of Audio Calls, video and audio calls are counted
separately and can not be used interchangeably.
separately and can not be used interchangeably.
It is only possible to schedule participants to dial in to the unmanaged bridge. Both SIP and H.323 are
supported.
supported.
If the conference includes participants that are direct-managed by Cisco TMS or registered to a Unified CM,
some limited monitoring of scheduled conferences hosted on unmanaged bridges is available in
some limited monitoring of scheduled conferences hosted on unmanaged bridges is available in
Conference
Control Center
. You can send participants messages, view basic details for each participant and add
participants to the conference.
Unmanaged bridge conferences are listed in
Booking > List Conferences
. Note that ending the conference
will result in the conference appearing as finished, but endpoints will stay connected.
A Network Integration license key must be purchased for each unmanaged bridge before adding it into Cisco
TMS. Up to 25 meeting addresses can be configured for each bridge, reflecting conference addresses
already created on the bridge itself.
TMS. Up to 25 meeting addresses can be configured for each bridge, reflecting conference addresses
already created on the bridge itself.
An unmanaged bridge can be configured as Immersive, if it supports hosting conferences including
multiscreen systems. Unmanaged bridges that are configured as immersive are preferred in routing if
multiscreen systems are added to a conference.
multiscreen systems. Unmanaged bridges that are configured as immersive are preferred in routing if
multiscreen systems are added to a conference.
The following features are not supported for unmanaged bridges in Cisco TMS: