Cisco Cisco Broadband Access Center Telco Wireless 3.7
C-32
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
DPE Configuration Commands
show device-config
Usage Guidelines
This command shows the configuration of the device configuration
Syntax Description
When entering the show device-config command, you must use this syntax:
show device-config <mac>
Where:
<mac>
—specifies a device’s MAC address
Examples
This is an example of how to use the show device-config command. For the purpose of this example
assume that the DPE MAC address is 1,6,00:00:00:00:00:03.
assume that the DPE MAC address is 1,6,00:00:00:00:00:03.
dpe# dpe show device-config 00:00:00:00:00:03
Retrieved the following configuration from DPE.
DHCP Configuration for device 1,6,00:00:00:00:00:03 in default provisioning-group
. . . . . . . . . . . . . . .
Note
The output of this command has been trimmed for demonstration purposes.
show dpe
Usage Guidelines
This command checks to see if the DPE is running and displays the state of the process and, if running,
its operational statistics. It does not indicate if the DPE is running successfully, only that the process
itself is currently executing. However, DPE statistics that this command prints when the DPE is running,
can be used to determine if the DPE is successfully servicing requests.
its operational statistics. It does not indicate if the DPE is running successfully, only that the process
itself is currently executing. However, DPE statistics that this command prints when the DPE is running,
can be used to determine if the DPE is successfully servicing requests.
Examples
These examples show how to use the show dpe command:
Example 1
dpe# show dpe
CSRC BPR Device Provisioning Engine is not running
Results:
These results occur when the DPE is not running.