Cisco Cisco Broadband Access Center Telco Wireless 3.7

dpe# show dpe

BPR Agent for BPR Provisioning Engine is running

dpe is running

Version BPR 2.5 (cbpr_25_L_200303251235).

Caching 0 device configs and 0 external files.

Received 0 cache hits and 0 misses.

Received 0 lease updates.

Connection status is Disconnected.

Sent 0 SNMP informs and 0 SNMP sets.

Received 0 MTA provisioning successful SNMP informs.

Received 0 MTA provisioning failed SNMP informs.

Running for 6 days 41 mins 35 secs.

Results:

These results occur when the DPE is running.

This command shows the current DPE settings used when it is restarted. It is used to verify that all 
executed commands have been executed successfully.

The shared secret is protected data that is not displayed when the command is run in a Telnet 
session. When the command is run through a console connection, the configuration information 
is displayed.

This is an example of how to use the show dpe config command:

dpe# show dpe config

dpe port = 49186

rdu host = host.cisco.com

rdu port = 49187

primary groups = Default

secondary groups = [no value]

This command is used whenever the DPE requires a new software upgrade, using uploaded upgrade files. 
These files, which end in the file extension .bpr, should be FTP’d into the incoming directory. The 
upgrade process scans all available updates and determines which ones are required. It separates the files 
into these categories:

invalid

—

These are the files that do not match the format required by the DPE.

not applicable—The DPE does not accept these patches because either the update is from an earlier 
version, or because the difference between versions (the current and updated versions) is too great.

applicable—The DPE can upgrade using these files.