Cisco Cisco Broadband Access Center Telco Wireless 3.7

Where:

<1..9999>—identifies the number of lines from the log file that you want to see.

This is an example of how to use the show packetcable snmp log last command:

dpe# show packetcable snmp log last 1

Error [SS_MSG] 2003-03-18 14:35:44,000 - SNMP Service Tracing Set To 800

This command displays the recent PacketCable SNMP service log file, and all new log messages, until 
the command is interrupted.

This is an example of how to use the show packetcable snmp log run command:

dpe # show packetcable snmp log run

Press <enter> to stop.

2001 08 17 11:43:43 CDT: %CSRC-5: Notification DPE: CSRC Device Provisioning Engine 

starting up

2001 08 17 11:43:44 CDT: %CSRC-6: Info DPE: Attempt to connect to RDU dpe .cisco.com:49187 

failed; 

2001 08 17 11:43:44 CDT: %CSRC-6: Info TFTP: Ready to service requests

Stopped.

This section describes the commands that affect the DPE SNMP agent features found in the DPE. These 
commands include:

This command is used to remove the specified host.