Cisco Cisco Unified IP Interactive Voice Response (IVR) 8.0(1) Installation Guide
Performing Pre-Installation Tasks
18
Installing Cisco Unified Contact Center Express Release 8.0(1)
Gathering Configuration Information for Installation
Use the following table to record the information about your server that both the
Answer File Generator and the basic installation wizard prompt you to enter.
Gather this information for each Unified CCX 8.0(1) server that you install. You
may not need to obtain all the information; gather only the information that is
pertinent to your system and network configuration. You should make copies of
this table and record your entries for each server in a separate table so it is easy
to configure your system.
Answer File Generator and the basic installation wizard prompt you to enter.
Gather this information for each Unified CCX 8.0(1) server that you install. You
may not need to obtain all the information; gather only the information that is
pertinent to your system and network configuration. You should make copies of
this table and record your entries for each server in a separate table so it is easy
to configure your system.
Note
Because some of the fields are optional, they may not apply to your configuration.
For example, if you choose not to set up an SMTP host during installation, the
parameter still displays, but you do not need to enter a value.
For example, if you choose not to set up an SMTP host during installation, the
parameter still displays, but you do not need to enter a value.
Caution
You cannot change some of the fields after installation without reinstalling the
software, so be sure to enter the values that you want.
software, so be sure to enter the values that you want.
The last column in the table shows whether you can change a field after
installation, and if you can, it provides the appropriate CLI command.
installation, and if you can, it provides the appropriate CLI command.
Table 6
Node Configuration Table
Parameter
Description
Can Entry Be Changed Post-Installation
Administrator
ID
ID
This field specifies the administrator
account user ID that you use for secure
shell access to the CLI, for logging into
Unified Communications Operating
System Administration and for logging
into the Disaster Recovery System.
account user ID that you use for secure
shell access to the CLI, for logging into
Unified Communications Operating
System Administration and for logging
into the Disaster Recovery System.
Yes, you can change the entry after
installation by using the following CLI
command:
installation by using the following CLI
command:
CLI > utils reset_ui_administrator_name
Your entry: