Cisco Cisco Web Security Appliance S670 User Guide

The appliance login screen appears. Enter the username and password to access the appliance. By 
default, the appliance ships with the following username and password:

Username: 

Password: 

Your session will time out if it is idle for over 30 minutes or if you close your browser without logging 
out. If this happens, you must re-enter the username and password.

Accept the terms of the end user license agreement by clicking the check box at the bottom of the page. 

Click Begin Setup to continue.

Configure the System Setting options, using the reference information in 

; then click Next.

Default System 
Hostname

The fully-qualified hostname for the Web Security appliance. This name 
should be assigned by your network administrator. This hostname is used to 
identify the appliance in system alerts.

DNS Server(s):  
Use the Internet’s Root 
DNS Servers

Configures the appliance to use the Internet root DNS servers for domain 
name service lookups.

You might choose this option when the appliance does not have access to 
DNS servers on your network.

The appliance requires access to a working DNS server in order to perform 
DNS lookups for incoming connections. If you cannot specify a working 
DNS server that the appliance can reach while you set up the appliance, you 
can configure it to use the Internet root DNS servers or temporarily assign the 
IP address of the Management interface so that you can complete the System 
Setup Wizard.

For more information about configuring DNS settings, see 

DNS Server(s):  
Use these DNS Servers

Specifies local DNS servers for domain name service lookups. You must 
enter at least one DNS server, and up to three total.

You can choose to use the Internet root DNS servers or specify your own 
DNS servers.

For more information about configuring DNS settings, see