Cisco Cisco Web Security Appliance S690 User Guide
2-16
Cisco AsyncOS 8.0.6 for Web User Guide
Chapter 2 Connect, Install, and Configure
Network Interfaces
A DNS server may return a result with both an IPv4 and an IPv6 address. DNS settings include an IP
Address Version Preference to configure AsyncOS behavior in these cases.
Address Version Preference to configure AsyncOS behavior in these cases.
Related Topics
•
•
Enabling or Changing Network Interfaces
•
Add or modify interface IP addresses
•
Change the Layer-4 Traffic Monitor wiring type
•
Enable split routing of management and data traffic
Step 1
Choose Network > Interfaces.
Step 2
Click Edit Settings.
Interface/Service
IPv4
IPv6
Notes
M1 interface
Required
Optional
Use of IPv6 addresses requires an IPv6
routing table that defines the default IPv6
gateway. Depending on the network, you
may also need to specify a static IPv6 route
in the routing table.
routing table that defines the default IPv6
gateway. Depending on the network, you
may also need to specify a static IPv6 route
in the routing table.
P1 interface
Optional
Optional
If the P1 interface has an IPv6 address
configured and the appliance uses split
routing (separate management and data
routes), then the P1 interface cannot use the
IPv6 gateway configured on the
Management route. Instead, specify an IPv6
gateway for the Data routing table.
configured and the appliance uses split
routing (separate management and data
routes), then the P1 interface cannot use the
IPv6 gateway configured on the
Management route. Instead, specify an IPv6
gateway for the Data routing table.
P2 interface
Optional
Optional
—
Data services
Supported
Supported
—
Control and Management Services
Supported
Partially Supported
Images, for example custom logos on
end-user notification pages, require IPv4.
end-user notification pages, require IPv4.
AnyConnect Secure Mobility (MUS)
Supported
Not Supported
—