Cisco Cisco TelePresence MCU 4510 Maintenance Manual
Configuring network and system settings
Cisco TelePresence MCU 4.3 Product administration guide
Page 170 of 242
Subnet mask
The subnet mask required for the IP address you want to
use, for example 255.255.255.0
use, for example 255.255.255.0
Default
gateway
gateway
The IP address of the default gateway on this subnet, for
example 192.168.4.1
example 192.168.4.1
IPv6 configuration
IP
configuration
configuration
Specifies whether the port should be configured manually
or automatically, or disabled. If set to Automatic via
SLAAC/DHCPv6 the MCU obtains its own IP address for
this port automatically. The protocol used will be SLAAC,
Stateful DHCPv6, or Stateless DHCPv6 as indicated by
the ICMPv6 Router Advertisement (RA) messages. If set
to Manual the MCU will use the values that you specify in
the Manual configuration fields below.
or automatically, or disabled. If set to Automatic via
SLAAC/DHCPv6 the MCU obtains its own IP address for
this port automatically. The protocol used will be SLAAC,
Stateful DHCPv6, or Stateless DHCPv6 as indicated by
the ICMPv6 Router Advertisement (RA) messages. If set
to Manual the MCU will use the values that you specify in
the Manual configuration fields below.
Manual configuration
IPv6 address
The (hexadecimal) colon-separated IPv6 address for this
port, for example [2001:db8:168:4::45].
port, for example [2001:db8:168:4::45].
See
for more
information about IPv6 addresses that are assigned
automatically.
automatically.
You only need to specify this option
if you have chosen Manual IP
configuration, as described above.
if you have chosen Manual IP
configuration, as described above.
If IP configuration is set to
Automatic via SLAAC/DHCPv6 this
setting is ignored.
Automatic via SLAAC/DHCPv6 this
setting is ignored.
When you enter an IPv6 address
anywhere in the user interface, the
address must be enclosed in
square brackets [ ].
anywhere in the user interface, the
address must be enclosed in
square brackets [ ].
Prefix length
The (decimal) prefix length value for the global IPv6
address for this port. In the above IPv6 address example,
the prefix length is 64.
address for this port. In the above IPv6 address example,
the prefix length is 64.
Default
gateway
gateway
Optionally, specifies the IPv6 address of the default
gateway on this subnet.
gateway on this subnet.
The address can be global or link-
local.
local.
IP status
Use the IP status fields to verify the current IP settings for the appropriate Ethernet port of the MCU, which
were obtained using DHCP/SLAAC or configured manually (see
were obtained using DHCP/SLAAC or configured manually (see
) including:
n
DHCP
n
IP address
n
Subnet mask
n
Default gateway
n
DHCPv6
n
IPv6 address
n
IPv6 default gateway
n
IPv6 link-local address