Cisco Cisco Web Security Appliance S690 User Guide
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
60
I R O N P O R T A S Y N C O S 6 . 3 F O R W E B U S E R G U I D E
11. Choose one of the following options described in Table 4-6.
12. Click Next.
The Administrative Settings page appears.
Figure 4-7 System Setup Wizard — Network Tab, Administrative Settings Page
13. Configure the Administrative Settings options.
Table 4-6 Transparent Connection Options in System Setup Wizard
Option
Description
Layer 4 Switch or No
Device
Device
Choose this option when the Web Security appliance is connected to a
layer 4 switch or if you will deploy the Web Proxy in explicit forward
mode after running the System Setup Wizard.
layer 4 switch or if you will deploy the Web Proxy in explicit forward
mode after running the System Setup Wizard.
WCCP v2 Router
Choose this option when the Web Security appliance is connected to a
version 2 WCCP capable router.
If you connect the appliance to a version 2 WCCP router, you must
create at least one WCCP service. You can enable the standard service
(also known as the “web-cache” service) during system setup, and you
can configure different or additional WCCP service groups after you run
the System Setup Wizard.
When you enable the standard service, choose whether or not to require
a password for the standard service group. If required, enter the
password in the password fields. The password can contain up to seven
characters.
For more information about creating WCCP services, see “Adding and
Editing a WCCP Service” on page 478.
version 2 WCCP capable router.
If you connect the appliance to a version 2 WCCP router, you must
create at least one WCCP service. You can enable the standard service
(also known as the “web-cache” service) during system setup, and you
can configure different or additional WCCP service groups after you run
the System Setup Wizard.
When you enable the standard service, choose whether or not to require
a password for the standard service group. If required, enter the
password in the password fields. The password can contain up to seven
characters.
For more information about creating WCCP services, see “Adding and
Editing a WCCP Service” on page 478.