Cisco Cisco 40 Gigabit Modules Installation Guide

The QSFP+ transceiver module is a static-sensitive device. Always use an ESD wrist strap or similar 
individual grounding device when handling QSFP+ transceiver modules or coming into contact with 
modules.

To remove a QSFP+ transceiver, follow these steps:

For optical QSFP+ transceivers, disconnect the network interface cable from the QSFP+ transceiver 
connector. 

For QSFP+ transceivers equipped with a bail-clasp latch (See 

, top view): 

Pivot the bail-clasp down to the horizontal position.

Immediately install the dust plug into the transceivers optical bore.

Grasp the sides of the QSFP+ transceiver and slide it out of the module socket.

For QSFP+ transceivers equipped with a pull tab latch (See 

, bottom view): 

Immediately install the dust plug into the transceiver’s optical bore.

Grasp the tab and gently pull to release the transceiver from the socket.

Slide the transceiver out of the socket.

Place the QSFP+ transceiver into an antistatic bag.

255435