Cisco Cisco Virtualization Experience Client 2212 Administrator's Guide

 shows the Serial tab. 

Use the following guidelines for the Serial tab:

Select Port—Select the port to which this setup definition applies. Either COM 1, COM 2, COM 3, 
or COM 4 can be selected (default is Port COM 1). For Models SX0 and VX0, COM 1 or COM 2 
selects from either the USB or serial device.

Baud Rate—Either 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 baud can be selected 
(default is 9600).

Parity—Either None, Even, or Odd can be selected (default is None).

Stop—Either 1, 1.5, or 2 stop bits can be selected (default is 1).

Size—Character size 5, 6, 7, or 8 bits can be selected (default is 8).

Flow Control—Either None, XON/XOFF, CTS/RTS, or Both can be selected (default is None).

Serial Touch Screen selections—Select the proper touch screen ELO, MicroTouch or FastPoint from 
the list.

Touch Screen on—Select the proper serial port (COM port) or None from the list.

Use the Touch Screen tab to configure touch screens that are connected to the zero client (USB). The tab 
is available (not grayed out) when the zero client detects that a touch screen is attached through a USB 
port and the setup (or calibration) has not been performed. The Touch Setup window prompts you to 
touch two circles on the screen to make the necessary calibration adjustment. After bring calibrated, the 
adjustment values are saved in the local terminal NVRAM until the system is reset to factory default, or 
another type of touch monitor is connected.