Cisco Cisco uBR-MC3Gx60V-RPHY Broadband Processing Engine Installation Guide

The following instructions describe the connection and removal process for the customized RF cables 
and the maintenance of the Cisco preconfigured cable bundles.

If you are returning a card to the factory, after removing the card from the chassis, immediately place it 
into an antistatic shielding bag.

For proper cooling and airflow, always install a blank cover on any empty slot in the Cisco uBR10012 
router chassis. Blank covers are available for all Cisco uBR10012 router modules. For information about 
specific modules, see the 

Replacement Cisco uBR10-MC5X20S card: UBR10-MC5X20S=
Replacement Cisco uBR10-MC5X20U card: UBR10-MC5X20U=
Replacement Cisco uBR10-MC5X20H card: UBR10-MC5X20H=
Blank uBR10012 card (if required): UBR10-MC-COVER=

1/4-inch flathead screwdriver

ESD-preventive wrist strap

Antistatic surface, such as a mat or antistatic bag

To unpack the Cisco uBR10-MC5X20S/U/H cable interface line card, complete the following steps:

Make sure you are properly grounded with an ESD-preventative ground strap. 

Remove the Cisco uBR10-MC5X20S/U/H cable interface line card from the box.

Place the card on an antistatic surface.

Remove the protective sticker covering the DS ports.

Review the installation information for the card.