Cisco Cisco 3600 Series 8-Port Asynchronous Synchronous Serial NM Troubleshooting Guide
Understanding 4−Port and 8−Port Async/Sync
Network Modules
Network Modules
Document ID: 7260
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Product Numbers
Features
Platform Support
Configuration
Related Information
Prerequisites
Requirements
Components Used
Conventions
Product Numbers
Features
Platform Support
Configuration
Related Information
Introduction
This document describes 4−port and 8−port async/sync network modules.
The 4−port (NM−4A/S) and 8−port (NM−8A/S) asynchronous/synchronous (async/sync) network modules
provide async connectivity with speeds up to 115.2 kbps, and sync connectivity with speeds up to 128 kbps.
These modules use the 60−pin "5−in−1" cables, similar to those used on the Cisco 2500 and Cisco 7000 series
routers.
provide async connectivity with speeds up to 115.2 kbps, and sync connectivity with speeds up to 128 kbps.
These modules use the 60−pin "5−in−1" cables, similar to those used on the Cisco 2500 and Cisco 7000 series
routers.
Figure 1 Asynchronous/Synchronous Network Module
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
Refer to the Platform Support section.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.